|
The weighing module VTA-TENZO D/1 enables the
detection of a load of 15 kg, the over range of the lift capacity
and the overload of the lift car necessary for the lift to
drive. LED directly on the electronics module indicates each of
the states. The current weight and the state of the weighing
module are displayed on the 5-digits LED display.
The microprocessor electronic module evaluates
the current loading of tensometer sensor, compares the
detected weight with the limit values for the existing lift type,
and activates the relevant relay outputs. Simultaneously it
displays the current weight on the display. The lift capacity can
be set using the DIP switches.
The detection of the unloaded floor weight and/or
the calibration of the weighing-device can be performed using the
button placed on the electronic module.
Advantages:
- One system encompasses the indication of the minimum load of
15kg, the over range of the lift capacity and the overload of
the lift car.
-
The installation is possible to the existing
lift car floor.
-
The current weight is displayed.
-
The basic states are displayed.
-
The system has been certified according to
the CSN EN 12015 and CSN EN 12016 (the electromagnetic
compatibility).
-
The electronics are covered IP54.
-
24 months guarantee
Basic technical parameters:
| Measured weight |
250 kg |
| Number of the sensors |
1 |
| Range of the sensors |
400 kg |
| Overload capacity of a
the sensor |
800 kg |
| Supply voltage |
24 V~, 24 V=, 12 V=
alternatively |
| Outputs |
relay outputs, 1 optically
separated output (galvanic separation) |
| Input |
galvanized detached (indication
of driving) |
| Range of the operating
temperature |
0–40°C |
|
